Single-phase transformer with 400Vac input and 230Vac output, 100VA power. Varnished transformer with IP-00 protection. Maximum current supplied is 0.43 A (apparent current).
The main application of this type of transformer is for command and control in industrial automation systems and for general applications. They are designed to power electrical devices where galvanic isolation between circuits is required. They are protected against moisture by resin impregnation.
These types of transformers are fully reversible.
The transformer can be secured with screws or on a DIN rail. The DIN rail must be secured using the dedicated accessory, reference KITDINKF1.5. This accessory is not included in the scope of delivery and must be purchased separately.
Technical characteristics of the transformer:
- Reference: TA001105400
- Transformer type: Single-phase
- Transformer type: Single-phase
- Primary voltage: 400Vac
- Secondary voltage: 230Vac
- Nominal power: 100VA
- Maximum intensity in the secondary (In): 0.43A
- Frequency: 50/60 Hz
- Dielectric strength between primary and secondary: 4600V
- Dielectric strength between primary and ground: 3500V
- Winding: copper wire, class H. Primary and secondary separated (galvanic separation)
- Protection level: IP00
- Protection class: I
- Insulation class: Tª 40ºC/F
- Connection: Screw-fastener terminals
- Weight: 1.83kg
- Transformer encapsulation: Varnished
- Mounting: By screws or DIN rail fixing
- Regulation: EN-61558-2-4
The transformer is supplied without any type of overload protection; it is mandatory to install them to avoid overloading the transformer.
The power and current indicated are apparent, the active current provided by the transformer will depend on the power factor of the connected load.
Professional use material, install in compliance with the regulations in force at the place of installation.
English 
Português PT
Adajusa SPAIN
Adajusa FRANCE
Adajusa ITALY
